Technical Specifications:
This is the NEW, INFINEON Brushless Motor Controller for eBike Motors. It has ON/OFF switch and is wired directly to Battery Pack with special Harness. Works with all chain drive and hub motors in the 36V-48V range optimized at 500W:- Cyclone, Nine Continent, Bafang, Crystalyte, BMC, PUMA, eZee, Wilderness Energy and other Motors.
Once the rocker switch in in the On position, the controller can be activated by (1) twist or thumb handlebar accelerator " Start Immediate" or (2) by pedaling and using P.A.S. to operate the motor at legal speed.
Standard Voltages Available : 36V and 48V
Custom Voltages Available: 60V and 72V
MAIN FUNCTIONS:
Low Voltage Protection insures that battery packs connected to the controller do not over-discharge.
On/Off switch insures battery packs do not self discharge to controller electronics when bike is not in use.
Both Battery Indicator and The Cycle Analyst Meter can be plugged in directly to the controller.
Has ability for Regenerative Braking with minor board modification.
SPECIFICATIONS
Voltage: 36V, 48V with Max at 60V
Low Voltage Cutoff: 20V
Continuous Current Handling : 22A
Maximum Current handling : 25A
Circuitry: 9 IRFL4030 Mosfets
Recommended Motors : 350, 500W (optimum), 550W, 600W
Dimensions: 6-inch x 3.25-inch x 1.75-inch
Weight: 0.6 kg
Shipping Weight: 1 kg
CONNECTORS:
Power Input & Controller Power - 3 wire Plastic Connector
eThrottle - 3 pin connector
eBrake Cutoff - 2 pin connector
Cycle Analyst- 6 pin connector
3 motor phase wires
5 Hall sensor wires for P.A.S.
OTHER FUNCTIONS:
1.forward and reverse
2.P.A.S.
3.Three Mode Settings (flat-normal-hill)
4.Auto cruise (if you maintain the same throttle setting for more 5 seconds ,you can relase the throttle and the controller will automatically maintain this speed setting)
MOQ: 40 If ordered with e-bike conversion kit or Battery/ Controller/ Charger Kit
MOQ : 100 If ordered alone.
|
